A fantastic all-round silencer that does well on both hunting and shooting range. A bestseller that can be recommended for both standard caliber and magnum calibers. It is a nice compromise between size, sound attenuation and weight. The completely symmetrical construction of the silencer means that the chance of increased precision and minimal shot deviation is optimal. In addition, all our silencers have so much recoil that they are a pleasure to use. It also means that you quickly become a better shooter. The Superdome has built-in Duo-Brake and is available both as a telescopic and front mounted.

diametercm  gramdb



Additional Information

The Superdome silencer is made of high-strength aluminum. The muffler consists of a rear chamber, an anterior chamber and 6 lamella elements with built-in stainless steel cones. The entire Dome range differs from other silencers on the market by having a significantly larger volume in the rear chamber. This reduces the pressure so that the powder gas is released more slowly from the silencer, and thus gives a significantly better sound attenuation.

The rear chamber is made of one piece of aluminum without joints. The pre-chamber encloses the Duo-Brake, which reduces the wear of the silencer and gives the thread double support to prevent the damper from being warped between threaded flange and pipe flange. In addition, Duo-Brake causes the silencer to be further clamped by the gun gas at the firing of the shot. The modules are equipped with stainless steel inserts to reduce wear. The Dome series has very close-fitting lamellae, which means that the powder gas has to pass through several chambers and therefore gives a better sound damping. The Superdome comes standard with 6 modules. If additional damping is desired, it is possible to purchase and install additional 5 modules. The surface of the silencer is black anodized to protect the surface of the silencer against corrosion.

Assembly and Maintenance

The Superdome is available with a variety of thread sizes, depending on the size of the rifle. It fits all rifles that have a diameter up to Ø20.5 mm.

The silencer is easily mounted without the use of tools. It is screwed onto the pipe until it meets its flange. Only then is the muffler straightened and it will sit straight and centered. The above is under the assumption that the thread of the rifle pipe is correctly made.

The silencer requires a minimum of maintenance. After use, remove the muffler to dry it for any. condensation and rainwater. After approx. 300 shots are used a brass or copper brush in oversize to release any. potting residues around the inner hole, after which vacuuming from both ends.

All of the Dome series silencers are controlled and specimen-mounted by specially trained professionals for checking the straightness..



WARNING! Be aware that the muffler can reach extremely high degrees of heat, so you should not touch it after prolonged firing series.